Toshiba RBC-AWSU52-UL - Louver Lock (Fixing the Angle of the Louvres)

–22–
Owner’s Manual
EN
Louver lock (Fixing the angle of the louvres)
You can set and fix the angle of louvres individually for each air outlet.
NOTE
• For models that “Louver setting” is not available, the message “No function” is displayed.
• Press [ Return] to not fix the changes, so conditions are as before changes, and return to the “Louver setting” screen.
• To cancel “Louver lock”, press [ ] and [ ] to set louvre not locked for the louvre angle of each louvre.
• When the operation mode is “Cool” or “Dry”, performing “Louver lock” at position (4) or (5) may cause condensation.
• For group connections, refer to <When multiple indoor units are connected as a group (group connection)>. (Page 57)
• “ ” is displayed when “Louver lock” is set.
1 In “Menu” (Page 17), select “Louver
setting”, and press [ Set/Fix]
2 Press [ ] and [ ] to select “Louver
lock”, and then press [ Set/Fix]
3 Press [ ] and [ ] to select louvres
 For louvre numbers of each indoor unit, refer to
<Individual louver (Select wind direction for each air
outlet)>. (Page 20)
4 Press [ ] and [ ] to select a louvre
angle (wind direction)
 Press [ ] to raise a louvre and press [ ] to
lower a louvre.
5 Press [ Set/Fix]
 Return to the “Louver setting” screen.
6 Press [ Return]
 “ ” is displayed.
 When doing group connections, the screen for
selecting units is displayed, so press [ Return] to
display “ ”.
Louvre 1
Louvre 2
Louvre 3
Louvre 4
All louvres
(1)
(2)
(3)
(4)
(5)
Louvre not
locked