Wireless remote controller kit Installation Manual
INSTALLATION OF SIGNAL RECEIVING UNIT
1. Removal of suction grille Fig. A
1) Slide the suction grille fixing knobs (2 positions)
toward the arrow direction, and then open the Suctiongrille
suction grille. (Fig. A) fixingknob
Suction grille
2) Remove the screws (2 pcs.) which are fixing
the wire guard. Using clamps mounted to the
wire guard, hang up the wire guard.
Do not remove the fixing screws of clamps of
the indoor unit.
Fig. B
Clamps
NOTE
After installation of the signal receiving unit, be sure
to mount the wire guard as original. (Fig. C)
Fig. C
Screws
\Wire guard
2 English-2
To Next Page
Loading...
