Wireless remote controller kit Installation Manual
HOWTO PERFORM CABLING OF SIGNAL RECEIVING UNIT
Connection diagram
Connection
• Connect the cables out of the signal receiving unit
to the terminal block for remote controller cabling of
the indoor unit. (There is no polarity.)
Signal receiving unit
Indoor unit P.C. board
Terminal block for
remote controller I . I CN001
cabiing _- White -_ I
Black
j I 2P white
REQUIREMENT
The control by two remote controllers is enabled by installing the wireless remote controller with the wired remote
controller for an indoor unit. (Max. 2 remote controllers of wireless or wired are installable.)
"2-remote controllers" controlling means that one or multiple units are operated by the multiple remote controllers.
NOTES
1. Upon confirmation of the terminal numbers of the indoor unit, connect the remote controller cables without
miscabling. (If applied AC 208/230 Volt, damage the unit.)
2. The multiple wireless remote controller kits cannot concurrently be used for an indoor unit.
3. When installing simultaneously the wireless remote controller with the wired remote controller, set one of them
as the sub remote controller.
• When setting the wired remote controller as the sub, exchange the address connector at the rear of RC.
board of wired remote controller from main to sub remote controller.
• When setting the wireless remote controller as the sub, turn No.3 of DIP switch [S003] on RC. board of
signal receiving unit from OFF to ON.
To operate an indoor unit by Wireless Wired
2 remote controllers remote controller kit remote controller
(Main) (Sub)
'_ The indoor unit is operated if @ _ (Sold
either wireless or wired remote Signal receiving unit separately)
controller is set as main or ', = Remote controller cable
sub remote controller. _ ' '
4, (Procured locally)
(Total cable length: Within 1312' 4" (400m)) _ - _,1 _,AWG20 (0.5mm =)
Terminal block for _ Use UL wires
remote controller ca_ rated 300V
I Indoor unit
Earth ,_-I I
To operate a group control of multiple indoor units
by 2 remote controllers
Wireless Wired
,_ Main and Sub remote controllers remote controller kit remote controller
are operable even if they are installed (Main) (Sub)
to any indoor unit. Si#nal _ Remote controller inter-unit [_l(Sold
receiving unit I ITr2] I cable forgroup control I FfT2] I separateIy)
(Total cable length: Within 656' 2" (200m)) '-_ (Procuredlocally) "_
÷ ÷ / AWG20 (0 5mm 2) i ,_
I I / Use UL wiies_ rated 300V .I I
Terminal block for"--!!-__,_"_"_--_-_"_ i
remote controller [- }:_it) _,! /- !_ 19 I,i _I
cabe __t__
Earth Earth Earth Earth
4 English-4
To Next Page
Loading...
