Wireless remote controller kit Installation Manual
HOWTO SET UP FORTHE HIGH CEILING
• When the height of ceiling to be installed with a filter exceeds 11' 6"
(3.5m), tap-up of DC fan is required.
Tap-up of DC fan can be set at No.2 (Tap 1) and No.4 (Tap 2) of DIP switch
[S003] on the signal receiving unit RC. board.
The signal receiving unit RC. board appears by removing screws at
the rear side of the signal receiving unit and the rear cover.
Setup for high ceiling
[S003] No.2 (Tap 1) and
[S003] No.4 (Tap 2) are used.
[S003] No.2 [S003] No.4 InstallabIe height
(Tap 1) (Tap 2) of ceiling
Standard (At shipment) OFF OFF 11' 6" (3.5m)
Type 1 OFF ON 13' I" (4.0m)
NOTE
Never set ON to DIP switch [S003] No.! (TEST RUN). (A TEST RUN is carried out on the remote controller.
(For the TEST RUN, refer to the Installation manual attached to the indoor unit.)
0 HOWTO HANDLETHE REMOTE CONTROLLER
• In case using remote controller mounting to the wall, etc.
Check a signal is received correctly by pushing I_ button at the position to be fixed.
• Replacement of battery
1. Holding the both ends of the cover and
remove it by sliding downward.
2. Correctly insert 2 AAA alkali batteries
matching + and - polarities with
indications.
3. Push ACL button with something
tipped and attach the cover. %_? ACLbutton
Cover
÷ ®
Mounting screw
Truss tapping
_0.16" x 0.63"
pull it toward you.
1 CAUTIONS FOR INSTALLATION OFTHE REMOTE CONTROLLER
• To operate the remote controller by fixing it to the wall, etc. with a remote controller holder, turn on the
fluorescent lamp, operate the remote controller at the position to be fixed, check the air conditioner normally
operates, and then mount it.
• When the room temperature is sensed by the remote controller, mount the remote controller paying attention to
the following items.
• Place not exposed directly to cold or hot wind.
• Place not exposed directly to the sunlight.
• Other places where the remote controller is not influenced.
2 EXPLANATION TO CUSTOMERS
• Hand over the "Owner's Manual" and "Installation Manuals" to the customer after installation works.
• Explain usage and maintenance of the remote controller according to "Owner's Manual".
6 English-6
To Next Page
Loading...
