Toshiba RBC-EXW21E2 - Rbc-Amt21 E

– 4 –
Operation section
Push each button to select a desired operation.
• The details of the operation needs to be set up once, afterward, the air conditioner can be used by pushing
(RBC-AMT21E) /
ON / OFF
button only.
UNIT
SET
CL
1
2
12
10
8
9
3
4
5
11
8
9
1
1
0
12
2
53
67 4
1
8
3
5
2
9
1
0
11
6
7
4
12
S
ET
TIME
TIMER SET
TEST
FIL
TER
L
L
RESET
TEMP
.
CL
FA
N
SA
V
E
A
A
S
WING/FI
X
VENT
MODE
ON / OFF
UNIT
LOUVER
<RBC-AMT21E> <RBC-AMT31E> <RBC-AMT32E>
1 Air volume select button
Selects the desired air volume mode.
2 Timer set button
TIMER SET button is used when the timer is set up.
3 Check button
The CHECK button is used for the check operation.
During normal operation, do not use this button.
4 Ventilation button
Ventilation button is used when a fan which is sold
on the market is connected.
• If “No function ” is displayed on the remote
controller when pushing the Ventilation button, a
fan is not connected.
5 Filter reset button
Resets (Erases) “ FILTER” display.
6 Power save operation (RBC-AMT32E only)
7 Swing/Wind direction button
Selects automatic swing or setting the louver
direction.
• This function is not provided to Concealed Duct
Standard Type, High Static Pressure Type,Floor
Standing Cabinet Type, Floor Standing Concealed
Type, or Slim Duct Type.
8 Operation lamp
Lamp is lit during the operation.
Lamp is off when stopped.
Also it flashes when operating the protection device
or abnormal time.
9 (RBC-AMT21E) /
ON / OFF
button
When the button is pushed, the operation starts,and
it stops by pushing the button again.
When the operation has stopped, the operation lamp
and all the displays disappear.
10 Operation mode select button
Selects desired operation mode.
11 Unit/Louver select button (RBC-AMT32E only)
Selects a unit number (left) and louver
number(right).
UNIT:Selects an indoor unit when adjusting wind
direction when multiple indoor units are controlled
with one remote controller.
LOUVER (4-way Air Discharge CassetteType 2H
series only):
Selects a louver when setting louver lock or wind
direction adjustment independently.
12 Set up temperature button
Adjusts the room temperature.Set the desired set
temperature by pushing TEMP. or TEMP.
( or RBC-AMT21E).
OPTION :
Remote controller sensor
Usually the TEMP. sensor of the indoor unit senses the
temperature. The temperature on the surrounding of the
remote controller can also be sensed.For details,
contact the dealer from which you have purchased the
air conditioner.
• In case that one remote controller controls the
multiple indoor units, the setup operation is unavail-
able in group control.