– 6 –
Part Name
• For Cooling Only type, , and are not displayed on LCD.
• Max. 8 indoor units can be operated by a remote controller.
• Once the operational items have been set, you can operate the previous condition by pushing the button only.
9 Selected mode displays
(Cooling only type)
Any one of , or can be displayed.
10 TEST is displayed during the Test Run.
11 (CHECK) is displayed when the protective
device has operated, or a fault has occurred.
12 is displayed during the operation.
If the remote controller setting is prohibited by the
central remote controller, will flash when the
[Start/Stop], [Operation Select] or [Temp.Setup]
button has been pushed and the change has not
been accepted.
13 The setup temperature is displayed.
14 Warning code is displayed when a fault has
occurred.
15 Selected fan speed, , , or displays.
16 is displayed when the remote controller
sensor is used.
1 Fan Speed button
2 Operation mode button
3 Swing/Air direction button
The flap angle is changed.
4 Temperature Setup button
For every push of the button, the temperature
increases by 1°C.
For every push of the button, the temperature
decrease by 1°C.
5 [Start/Stop] button
6 Check button (Used in servicing)
• Do not use this button in normal operation.
7 Remote control temperature sensor
Usually controlled by the indoor unit sensor, it can
be changed to the remote controller. For
details,contact the dealer who you purchased the air
conditioner from. (When using a group control
method, do not use the remote controller sensor.)
8 Selected mode displays (Heat pump type)
Any one of , , , or can be displayed.
While is displayed, the indoor fan stops or the
mode is set to Low speed setting.
[AUTO] mode is displayed on heat recovery type
only.
C
F
TEST
SETTING
1
2
3
7
6
5
4
C
F
TEST
SETTING
12
13
14
11
10
15 16
89
The following display is for explanation only and differs from the real display.
• When turning on the power switch to the remote controller for the first time,
the flashes. While is displayed, the automatic model check is operating.
Operate the remote controller after symbol has disappeared.
To Next Page
Loading...
