Toshiba RBP-RC001-E - Page 52

32RCA001TS-02ISEN
52
RBP-RC001-E Installation & Owner's Manual
DN code Item Description
Initial
value
Restart
016
MC in/out temp Min
flow rate calc
Sets the lower limit flow for the inlet/outlet average temperature calculation
for the system based on the quantity of heat. In the constant flow region,
the average temperature may be shifted due to a flow error.
If the flow of the MC is below the setting, the simple average value of the
inlet/outlet temperature is used.
50
Not
neces-
sary
0A0
Model setting for
system 1
Switches the operation pattern setting range and the screen display items
according to the model setting.
0: USX, EDGE Series
1: SFMC Series 4, 5
2: CAONS700
3: Heat Recovery CAONS Series 1
5: Heat Recovery CAONS Series 2
* If you change the model setting, the operation pattern mode and the set
temperature are changed to setting values that are valid for the model. If
you changed the model setting, be sure to check the operation pattern
setting.
0
Not
neces-
sary
0A1
Model setting for
system 2
0
Not
neces-
sary
0A2
Model setting for
system 3
0
Not
neces-
sary
0A3
Model setting for
system 4
0
Not
neces-
sary