RemotEye 4 User Manual – 90988-007 131
A.3 MODBUS (3X) INPUT REGISTERS FOR SINGLE PHASE UPS: MONITORING
All Registers – Size: 16-Bit, Access: Read-Only.
Note: The Modbus registers table style addressing is protocol base 0. If monitoring software uses PLC style addressing base 1, add one to the register number. For
example, Modbus address 30001 becomes PLC address 30002 ; address 10001 becomes PLC address 10002.
Note 2: Please make sure the latest RemotEye 4 firmware revision is installed in order to use the Modbus register table below. If not, there will be inconsistencies
between RemotEye 4 internal register addressing and this manual. Go to www.toshibaups.com to get the latest RemotEye 4 firmware.
MODBUS (3X) INPUT REGISTERS – SINGLE PHASE PLATFORMS
RemotEye 4 System Information
RemotEye 4 Software Version
RemotEye 4 Slave ID Number
Gateway IP Address First Byte
Gateway IP Address Second Byte
Gateway IP Address Third Byte
Gateway IP Address Fourth Byte
RemotEye 4 Installation Date
RemotEye 4 Installation Date
RemotEye 4 Installation Date