22 RemotEye 4 User Manual – 90988-007
RADIUS (security protocol) – Allows the RemotEye 4 to work with a centralized RADIUS server before
allowing the user to access monitor or manage the Toshiba UPS.
Interface settings – Allows simple configuration of the network protocols for the serial RS-232/RS-485
ports.
The UPS image on the Dashboard can be replaced at any time by the administrator. Image size restriction
is a single 100kb max. JPEG
Automatic Save Log – Allows saving UPS and RemotEye 4 history logs to a dedicated UPS monitoring
workstation.
Battery Test – Several of the UPS are capable of conducting battery test. The RemotEye 4 allows
scheduling automatic battery tests to help monitor backup battery fitness.
Mobile Friendly Page – A mobile-friendly web page allows monitoring on smartphones.
IPv6 Ready – Capable of merging into your expanding network.
Automatic Firmware Upgrades
Email Notifications
Protected Clients Shutdown – RemotEye 4 can initiate an orderly shutdown to connected virtualization
operating systems in case of power outage.
2.6.5 RemotEye 4 Support Software Programs
Use of the following programs further expands the flexibility of RemotEye 4.
Remote Client Shutdown for ESXi – Remote shutdown of ESXi servers can be accomplished by installing the
separate program RemotEye ESXi Client Shutdown Daemon. The program is software that is installed onto the
ESXi server. This allows the RemotEye 4 to communicate with the Client Software to broadcast system failure
messages via an IP (Internet Protocol) packet and to perform unattended graceful shutdown of up to 250 clients.
See Section 11.1
Auto-Save Log – An easy to configure utility tool that allows administrators to automatically save history logs from
one to multiple RemotEye 4s at the same time to a computer’s hard drive. See Section 11.3
Tupgrade – Manually upgrade RemotEye 4 firmware using Tupgrade. RemotEye 4 Firmware Upgrade Utility is
an easy to use network upgrade utility tool that allows user to upgrade to a newer firmware version when available.
See Section 11.5.
2.6.6 Optional – Environmental Monitoring Device (EMD)
The Environmental Monitoring Device (EMD) (Sold Separately) allows the RemotEye 4 to monitor environmental
temperature and humidity.
It also provides two dry contact closures, which can be used with Toshiba’s RemotEye Sensor Pack (sold
separately), that can be set for normally open, normally closed, active high, or active low conditions. When an
EMD event is triggered the RemotEye 4 can send an email notification and SNMP Trap with the description of the
event (See Figure 2-6 EMD Module). (Part Number: RMTI-EMD-HT)
To Next Page
Loading...
