Toshiba RemotEye 4 - UPS MANAGEMENT Drop-Down Menu; SETTTINGS Drop-Down Menu; EMD Drop-Down Menu; Username} Drop-Down Menu

46 RemotEye 4 User Manual – 90988-007
 Output Parameter: Output Voltage/Current/Frequency/Power/etc.
 Bypass Parameter: Output Voltage/Current/Frequency/Power/etc.
 DC Bus Parameter: DC Bus Positive/Negative/Rated Voltage.
 Battery Parameter: Battery Voltage/Current/Charging Current/detection levels/etc.
 UPS Home Group: Displays the Name/IP Address/UPS Mode of all RemotEye devices in the same
network.
 Protected Clients: Displays the Name/IP Address/Shutdown Delay of the current protected
computers/servers.
 Alert Center: Date/Event
 History Logs: Individual logs for System/Inverter/Backup Operations as well as Total number of
Overloads/Backups/Faults/etc.
5.3.2 UPS MANAGEMENT Drop-down Menu
Ref. Figure 5-14 Drop-Down Menus
This is a comprehensive of all UPS MANAGEMENT options. Note: Not all options apply to all models of UPS’s.
 UPS Configuration General: Set Password/System Name/Rated in-Out Voltage/Battery Data
 UPS Configuration Display: Set Sleep Timer and Buzzer Status.
 UPS Control: Adjust output voltage, enable RMTI-4 Control, Configure Startup/Restart/Transfer delay
 Battery Test: Start/Elapsed Time, set Test Schedule, Test Results
 UPS Shutdown Events: Shutdown Events, Shutdown Action, Shutdown Delay
 Non/Recurring On/Off: UPS Shutdown Scheduler.
5.3.3 SETTTINGS Drop-down Menu
These settings can be accessed from the SETTINGS menu (Ref. Figure 5-14 Drop-Down Menus):
(This is a comprehensive of all SETTINGS options. Note: Not all options apply to all models of UPS’s.)
 SNMP Settings: Configure RemotEye 4 to work with SNMP.
 Modbus Settings: Configure RemotEye 4 to work with Modbus TCP or RTU.
 BACnet Settings: Configure RemotEye 4 to work with BACnet IP or MSTP.
 Email Settings: Enter email’s to receive warnings/ notifications
 RADIUS Settings: Configure RemotEye 4 to work with the RADIUS server.
 Interface Settings: Configure RemotEye 4 to work with either the RS-232 or RS-485 serial port. Used for
either BACnet MSTP or Modbus RTU.
 Configuration Capture Tool: Record snapshot of current configuration. Used to configure other
RemotEye 4s.
 Wireless: Configure RemotEye 4 to work with wireless features.
 Reminders: Set reminders
 RemotEye 4 System Settings: Edit RemotEye 4 configuration settings that were entered during initial
setup.
5.3.4 EMD Drop-down Menu
Ref. Figure 5-14 Drop-Down Menus
 EMD Configuration: Set the parameters and limits for the optional EMD device.
5.3.5 {Username} Drop-down Menu
Ref. Figure 5-14 Drop-Down Menus
 Edit Dashboard: Enables rearranging/replacing some of the widgets on the Dashboard.
 Logout: Exit the ADMIN mode.