110 RemotEye II User Manual – 50024-014
Tupgrade Firmware Tool
General information
To perform a firmware upgrade, the RemotEye II must be connected to the same network as the
workstation from which the upgrade file is to be sent. In the RemotEye II make sure the Network
Upgrade Control is enabled, under RemotEye II Control, and that users have the Admin login and
Password string information.
Here is the way to manually upgrade RemotEye Firmware:
1) Web Interface: Go to RemotEye II Management
RemotEye II Control menu then Enable
Network Upgrade Control.
1.1. Note: To enable the Network Upgrade user has to change the security level to administrator
by logging in as Administrator.
2) Open the Tupgrade application software and click on the Discover icon. If no RemotEye units
auto populate the list, press on the + icon and enter the IP, Username, and Password. If it still
does not appear check your network security and your computer firewall.
3) Select the check box right next to the RemotEye that will be updated.
4) Select the Edit button and enter the Username and Password.
5) Select the Open File button and select the firmware to be uploaded.
6) Select the Upgrade Firmware button to start the upgrade process.
Figure 30: Tugrade Utility – Opening Display
Figure 31: Tugrade Toolbar Functions
Manually set found device IP address, subnet mask and gateway
Get all device parameters. This generates a config file.
Use default browser to open homepage of selected device
Pop-up Add dialog to add one device
Delete one or more selected devices.
Pop-up Edit dialog to modify a device configuration.
Discover all RemotEye devices on the network.
Open the location (directory) of uploaded file.
Upgrade firmware after unit selected and file uploaded
To Next Page
Loading...
