RemotEye II User Manual – 50024-014 121
Figure 0-6 WinSCP vi-admin Screen
11.3. Close WinSCP program.
12. Return to the vMA command prompt and change the directory where the SD_ESXi_TSB_V100.tar
was placed in step 10.
13. Extract the software: Type “tar xvf SD_ESCi_V100.tar” in the command prompt and press Enter.
14. Go to the newly created folder SD_ESXi_TSB: Type “cd SD_ESXi_TSB” and press Enter.
15. Install the software: Type “sh install.sh” in the command prompt and press Enter. Follow the
instruction prompts. (See Figure 0-7)
Figure 0-7 Install Screen Shot
16. Verify that RemotEye and ESXi server are communicating. Go to RemotEye web interface and look
for the "Connected Client Table" web page. Open the Connected Client Table web page. (See
Figure 0-8)
To Next Page
Loading...
