RemotEye II User Manual – 50024-014 19
Making the Network Connection
Each Ethernet network is different. Therefore, the following steps should be used as an outline for
connecting the RemotEye II to a network:
1. Connect one end of a Category 5 cable to the NETWORK RJ45 receptacle of RemotEye II.
2. Connect the other end of the Category 5 cable to a designated network switch or hub. A
network administrator will allocate an available port.
3. Verify a network link has been established. On RemotEye II/External, confirm Traffic LED on
RemotEye II is illuminated. On RemotEye II/Internal, confirm the leftmost, green LED is
illuminated.
To Next Page
Loading...
