RemotEye II User Manual – 50024-014 45
Battery Parameters
This page provides the battery status and battery run-time information. This page will refresh
automatically at a user-defined rate. To change or view the refresh rate setting, select RemotEye II
Management - HTTP Page Refresh Rates.
Battery Status
This field shows the status of the UPS batteries. These readings include: Unknown, Normal, Low,
Depleted, Discharging, and Failure.
Elapsed Time On Battery Power
This field shows the elapsed time (in seconds) since the UPS switched to battery power.
Battery Capacity Remaining (option)
This field shows the remaining battery capacity expressed as a percentage of full capacity.
Battery Estimated Minutes Remaining (option)
This field shows the remaining minutes of the UPS to sustain the current load.
Battery Voltage
This field shows the battery voltage in VDC.
Battery Voltage Percent
This field shows the battery voltage in %.
Battery Current (option)
This field shows the present battery current in %.
Battery Temperature (option)
This field shows the internal UPS temperature expressed in
o
C.
Battery Last Replaced Date
This field shows the last replacement date of the UPS system's batteries. This value is displayed in the
dd/mm/yyyy format. When the UPS batteries are replaced, this value should be adjusted accordingly by
the service center.
Battery Life Remaining
This field shows the remaining battery life. The maximum battery lifetime is 5 years. This shows the
remaining battery lifetime in months.
Battery Rated Backup Time
This field allows the administrator to configure the estimated battery backup time (in minutes) during
power failure at 100% load. The default is 0 minutes.
To Next Page
Loading...
