86 RemotEye II User Manual – 50024-014
Manipulating RemotEye II Passwords
The general progression for altering any passwords within the Toshiba MIB is the following:
Send an SNMP set request of upsPasswordAccess to RemotEye II. This enables the upsPassword
table.
Send an SNMP set request of upsPasswordCurrent Password, or upsPasswordControlPassword,
depending on which password requires alteration.
Send an SNMP set request of upsPasswordAccess to RemotEye II.. This disables the upsPassword
table and secures the passwords.
Default Passwords
The default values for the passwords are:
upsPasswordAccess – The default value is toshibA factorY passworD. However, this MIB object will
always accept the value of upsPasswordCurrent Password as well.
upsPasswordControlPassword – The default value is v2password.
upsPasswordCurrent Password – The default value is v2password.
To Next Page
Loading...
