⎯ 118 ⎯
6 F 2 S 0 7 1 5
■Selecting Options
This part describes how to select the options.
《Note for Operation》
● The following selections are available.
・Hard Copy Mode When a color printer is concocted to the PC, you
can select color or monochrome printing to make a
hard copy.
・Phase You can select the leading display or delay display
for the phase difference of waveforms.
・Unit at Start You can select a unit for the time displayed when a
waveform data is displayed.
・Value You can select the primary value display or the
secondary value display for the measurement and
analysis values.
・Fault Section Calculation You can select whether the fault time is calculated
automatically at the same time with the waveform
display or not.
● The option selections are common to all the waveform data.
《Operating Procedure》
① On the [Set] menu, click [Option].
② Select an option that you want to select for each item.
Note: When no voltage is input, remove the check (ν) in the “Fault Selection
Calculation” checkbox.
③ Click【OK】button.
･ The selected options are set.
2-6
To Next Page
Loading...