⎯ 122 ⎯
6 F 2 S 0 7 1 5
■Displaying Phase Difference
This part describes how to display the phase differences at the active cursor position.
《Note for Operation》
● You can select the leading display or delay display for the phase differences.
(→2.1 Setting Parameters for Measurement and Analysis ■Selecting Options)
《Operating Procedure》
① Display the active cursor at the measurement point.
② On the [Measurement] menu, click [Phase Difference].
③ The phase differences of the channels to the reference phase are displayed.
･ The reference phase is marked with [*].
･ You can update the values by moving the cursor.
･ [--------] is displayed in the channel where the value can not be measured.
2-10
To Next Page
Loading...