⎯ 124 ⎯
6 F 2 S 0 7 1 5
■Displaying Harmonics
This part describes how to display the harmonics for 4 cycles before and after the active cursor
position.
《Note for Operation》
● You can select the primary values or the secondary values for the
fundamental wave of harmonics.
(→2.1 Setting Parameters for Measurement and Analysis ■Selecting Options)
《Operating Procedure》
① Display the active cursor at the measurement point.
② On the [Measurement] menu, click [Harmonics].
③ The harmonics of the channels are displayed.
･ The harmonics for 4 cycles before and after the cursor position are calculated.
･ You can display the harmonics up to 11th by clicking【Next】button.
･ You can update the values by moving the cursor.
･ [--------] is displayed in the channel where the value can not be measured.
2-12
To Next Page
Loading...