F. GETTING STARTED
6
E. OPERATION PANEL
1.Plug the power supply cord into a properly grounded wall outlet,;
the 3 pilot lamps will light up then go off, one at time ,form
left to right.
4.The low/empty water pilot lamp will ash when the water level
in the bottle is low or when the bottle is empty.
heating pilot lamp
cooling pilot lamp
lacking water pilot lamp
Note: Be sure that the ground pin of the unit’s 3-pin power cord plug is inserted into the
electrical outlet hole for grounding. Also, this hole must be reliably connected to a
grounding provision.
2
3
To Next Page
Loading...