7
heating
cooling
switch
switch
OF F
ON
OF F
ON
(Green)
(Red)
1. Open the lower door.
2. Hang the probe assembly on probe hanger.
3. Place a fresh bottle outside the cabinet.
4. Clean the outside of new bottle with a cloth.
5. Insert the probe into the bottle.
6. push the probe assembly downward until it
7. Slide the bottle into the cabinet and the close
Installing a Water Bottle
Probe
assembly
lower door
probe
hanger
clicks in place and until the tube hits the
First, make sure that the two switches at the rear top portion of the unit are turned OFF.
If these switches are turned ON when the plug is inserted into an outlet, the water dispenser
will be damaged. Plug the power supply cord into a properly-grounded wall outlet. The pump
will then start to move water from the water bottle to the hot and cold tanks and it will take
around 3~4 minutes to ll both tanks for the rst time. During this period, the pump will
continuously run and this is normal.
Supply Electricity
at the rear top
portion of the unit
bottle of the bottle.
door.
To Next Page
Loading...