110 Series 4-13
6. Remove four M3x4 flat-head screws securing the frame to the HDD and
separate the HDD from the frame.
Figure 4-10 Removing the HDD from the frame
Installing the HDD
To install the HDD, follow the steps below and refer to Figures 4-9 and 4-10.
1. Secure the HDD frame to the HDD with four M3x4 flat-head screws.
2. Attach the HDD brace to the HDD frame.
3. Seat the HDD in the computer and press to secure the connection. Carefully
insert the pins to start the connection. Then lower the HDD and press to push all
the way in.
4. Secure the HDD frame to the computer with two M2.5x6 screws.
5. Install the optional memory module, optional PC card, and battery pack as
described in Sections 4.4, 4.3, and 4.2.
To Next Page
Loading...
