4-20 110 Series
4.8 RTC Battery and Top Cover with Display Assembly
Removing the RTC Battery and Top Cover with Display Assembly
To remove the RTC battery and top cover with display assembly, follow the steps below and
refer to Figures 4-19 to 4-21.
1. Turn the computer off. Disconnect the AC power cord and all external cables
connected to the computer.
2. Remove the battery pack, optional PC card, optional memory module, HDD,
keyboard, sub-battery, and VGA board as described in Sections 4.2 through 4.7.
3. Turn the computer upside down and remove three M2.5x8 silver screws from
three corners of the bottom cover.
4. Remove four M2.5x6 screws from the battery slot.
Figure 4-19 Removing the top cover screws
5. Turn the computer over and lift back the top cover with display assembly so you
can disconnect cables.
To Next Page
Loading...
