110 Series 4-21
6. Disconnect the Real Time Clock battery cable from PJ3 on the system board
and remove the battery.
WARNING: If you replace the RTC battery, be sure to use only batteries
recommended by Toshiba. Installation of the wrong battery can cause the
battery to explode or otherwise cause damage.
Figure 4-20 Removing the RTC battery
7. Disconnect the panel sensor close cable from PJ10.
8. Carefully lift the LED pressure connector. Then remove the LED cable from
PJ14 on the system board.
9. Remove one M2.5x8 screw from the sub-battery base. Remove one M2.5x6
screw securing the ground wire from the system board. Remove the tape
securing the display ground cable.
To Next Page
Loading...
