4-32 110 Series
4.13 Display Mask
Removing the Display Mask
To remove the display mask, follow the steps below and refer to Figures 4-30 and 4-31.
1. Turn the computer off. Disconnect the AC power cord and all external cables
connected to the computer.
2. Remove the battery pack, optional PC card and optional memory module as
described in Sections 4.2, 4.3, and 4.4.
NOTE: It is not necessary to remove the top cover with the display
assembly.
3. Remove two rubber seals from the display hinges and two rubber cushions
from the top corners to expose screws securing the display mask.
NOTE: Support the back of the display with your hand when you remove the
screws.
4. Remove four M2.5x6 screws that were covered by the rubber seals and cushions.
Figure 4-30 Removing the rubber seals, cushions, and screws
To Next Page
Loading...
