110 Series 4-41
6. Remove the shielded tape securing the display cables to the LCD cover.
Figure 4-37 Removing the LCD module (110CS with DSTN)
Installing the LCD Module
To install the LCD module, follow the steps below and refer to Figures 4-36 and 4-37.
1. Secure the display cable to LCD cover with shielded tape.
2. Connect the display cables to PJ2, PJ3, and PJ4 on the flexible cable and
connect the flexible cable to the display module. Be sure to fit the flexible cable
under the plastic guide before seating the LCD module.
3. Carefully rotate the LCD module into the LCD cover.
NOTE: Support the back of the display with your hand when you secure the
screws.
4. Secure four M2.5x6 screws on the LCD module. Make sure the ground cable is
secured at the left bottom corner.
5. Install the FL inverter board, display mask, optional memory module, optional PC
card, and battery pack as described in Sections 4.15, 4.13, 4.4, 4.3, and 4.2.
To Next Page
Loading...
