3-38 110 Series
2. Good Track FORMAT
Formats a specified cylinder and track as a good track. If a good track is format-
ted as a bad track, use this option to change the track to a good track.
3. Bad Track FORMAT
Formats a specified cylinder and track as a bad track. If a bad track is detected,
use this option to label it as a bad track.
4. Bad Track CHECK
Searches the hard disk drive for bad tracks by reading data to all the tracks on the
hard disk drive. A list of bad tracks displays when the program is complete. If an
error other than a bad track is detected, the program automatically terminates.
3.17.2 Operations
NOTE: After the HDD has been formatted, execute the Toshiba MS-DOS FDISK
command to partition the HDD. Next, execute the Toshiba MS-DOS FORMAT com-
mand. Refer to the Toshiba MS-DOS manual for more information about using these
commands.
Selecting Test 2 and pressing Enter in the Diagnostics Menu displays the following mes-
sages:
DIAGNOSTICS - HARD DISK FORMAT : VX.XX
1 - All track FORMAT
2 - Good track FORMAT
3 - Bad track FORMAT
4 - Bad track CHECK
9 - Go to TEST MENU
↑↓→← : Select items, Enter: Finish, Esc: Exit
1. All Track FORMAT
Pressing 1 selects All track FORMAT, which lets you format the entire disk.
[All track FORMAT]
Drive : #1 = HDD #2 = Non
Cylinder : XXXX
Head : XX
Sector : XX
<<< Model name = >>>
To Next Page
Loading...
