Toshiba Satellite 110 Series - Connecting the Computer to the Noteworthy Port Replicator

Using Your Computer on Your Desk
Using the Optional Noteworthy Port Replicator
Part I: Getting To Know Your Computer
181
The
serial connector
connects to the computer’s serial port.
The
power connector
connects to the computer’s power socket.
The
parallel connector
connects to the computer’s parallel port.
The
monitor connector
connects to the computer’s monitor port.
The
docking lever
secures the computer to the Port Replicator.
Connecting the Computer to the Noteworthy Port Replicator
To connect your computer to the Port Replicator, follow these
steps:
1 Turn the computer off.
2 Remove all cables from the back of the computer.
3 Place the Port Replicator on a level surface with the front
facing you.
4 Holding the Port Replicator with your left hand, push the
docking lever
away from you.
The
guide pins
on the Port Replicator move forward to receive
your computer.
Aligning the computer with the guide pins
5 Align the two holes on the bottom of the computer with
guide pins
on the Port Replicator.
6 Set the computer on the guide pins.
Guide pins
Docking lever