116
Learning the Basics
Using Standby
5.375 x 8.375 ver 2.4.0
7 Click Override all Modes with settings here.
The Set the range window appears.
Sample Set the range window with DC only option
8 Do one of the following:
❖ Click DC only for the settings to apply only when
you are using battery power.
❖ Click All for the settings to apply whether you are
using battery power or outlet power.
9 Click OK to close the Normal Power Properties window.
10 Click OK to close the TOSHIBA Power Saver Properties
window, then close the Control Panel.
Starting again from Standby
To start the computer from Standby mode, press the power
button until the on/off light changes to green. The computer
returns to the screen you were using.
If you put the computer in Standby mode by closing the
display panel, you can start the computer again by opening
the display panel.
To Next Page
Loading...
