8-10 Optional Devices User's Manual
Satellite 2670/2710 User's Manual – 2670_UK.doc – ENGLISH – Printed on 19/01/00 as
IM_267UK
PS/2 mouse
Use the PS/2 mouse/keyboard port on the computer.
Make sure the mouse has a cable with a 6-pin connector for the PS/2
mouse port. If the mouse’s cable is not compatible, see your dealer for an
adaptor cable.
How the computer treats the connection to a PS/2 mouse depends on the
setting for Pointing Devices under the Hardware Setup or TSETUP
program. If Simultaneous is selected, you can operate both the
AccuPoint II and a PS/2 mouse. If Auto Selected is chosen, the
AccuPoint II is disabled when a PS/2 mouse is connected. The
Simultaneous setting might not work with some PS/2 mouses.
To connect a PS/2 mouse:
1.
Turn the computer off.
2.
Connect the PS/2 mouse to the PS/2 mouse/keyboard port on the
computer, pressing gently to assure a firm connection.
3.
Turn on the computer.
To disconnect the mouse, turn off the computer and pull out the mouse
connector.
Consult your mouse manual for instructions on how to install necessary
software.
PS/2 keyboard
Use the PS/2 mouse/keyboard port on the computer. When an external
keyboard is connected, you can use both the external keyboard and the
computer’s internal keyboard. To connect a PS/2 keyboard:
1.
Turn the computer off.
2.
Plug the PS/2 keyboard connector into the PS/2 mouse/keyboard port
on the computer, pressing gently to assure a firm connection.
3.
Turn on the computer.
To disconnect the keyboard, turn off the computer and pull out the
keyboard connector.
To Next Page
Loading...
