Toshiba Satellite 2670 series - Accupoint II Precautions; Replacing the Cap

4-2 Operating Basics User's Manual
Satellite 2670/2710 User's Manual – 2670_UK.doc – ENGLISH – Printed on 19/01/00 as
IM_267UK
AccuPoint II precautions
Under certain conditions, the on-screen pointer may travel contrary to
AccuPoint II operation or an error message may appear. For example, if

You touch the AccuPoint II during power-up.

You apply constant, soft pressure to the AccuPoint II.

There is a sudden temperature change.

Strong stress is applied to the AccuPoint II.
If an error message appears, reboot the computer. If an error message does
not appear, wait a moment for the pointer to stop, then continue operation.
Replacing the cap
The AccuPoint II cap is an expendable item that should be replaced after
prolonged use. There are spare AccuPoint II caps supplied with the
computer.
1.
To remove the AccuPoint II cap, firmly grasp the cap and pull it straight up.
ACCUPOINT II CAP
PEG
Removing the AccuPoint II cap
2.
Position a new cap on the peg and press it into place.
The peg is square, so be careful to align the cap’s square hole with the peg.