7-2 Setup and Password Security User's Manual
Satellite 2670/2710 User's Manual – 2670_UK.doc – ENGLISH – Printed on 19/01/00 as
IM_267UK
Executing TSETUP
1.
Select
Restart (the computer) in MS-DOS mode?
from the
Shut
Down
window.
2.
After the computer reboots in MS-DOS, type
TSETUP
and press
Enter
.
TSETUP displays the SYSTEM SETUP screen.
The TSETUP screen is divided into two pages SYSTEM SETUP (1/2)
and SYSTEM SETUP (2/2).
MEMORY
Total = 65536 KB
BATTERY
Battery Save Mode = Full Power
PASSWORD
Not Registered
DISPLAY
Power On Display = Auto-Selected
LCD Display Stretch = Disabled
TV Config.
BOOT PRIORITY
Boot Priority = FDD→HDD→CD-ROM
Power On Boot Select = Enabled
OTHERS
CPU Cache = Enabled
Level 2 Cache = Enabled
Processor Serial Number = Disabled
Auto Power On = Disabled
Alarm Volume = High
System Beep = Enabled
CD Power SW Mode = CD Play
PERIPHERAL
Pointing Devices = Auto-Selected
Ext Keyboard "Fn" = Disabled
USB Legacy Emulation = Disabled
Parallel Port Mode = ECP
Hard Disk Mode = Enhanced IDE (Normal)
SYSTEM SETUP (1/2) ACPI BIOS version = x.xx
CONFIGURATION
Device Config. = All Devices
I/O PORTS
Serial = COM1(3F8H/IRQ4)
Built-in Modem = COM2(2F8H)
Parallel = LPT1(378H/IRQ7/CH3)
FLOPPY DISK I/O
Floppy Disk = (3F2H/IRQ6/CH2)
DRIVES I/O
HDD = Primary IDE(1F0H/IRQ14)
CD-ROM = Secondary IDE(170H/IRQ15)
PCI BUS
PCI BUS = IRQ11
SYSTEM SETUP (2/2) ACPI BIOS version = x.xx
PC CARD
Controller Mode = Auto-Selected
: €Select items Space, BkSp: Change values PgDn, PgUp: Change pages
Esc: Exit without saving Home: Set default values End: Save changes and Exit
The system setup screen
Changing values in the TSETUP menu
1.
Press
←
and
→
to move between the two columns. Press
↑
and
↓
to
move between items in a column.
2.
Press either the space bar or
BkSp
to change the value.
3.
Press
PgUp
or
PgDn
to change pages.
On either page, you can go directly to a specific group by pressing the first
letter (highlighted) of the group’s name. For example, press
B
to go to the
Battery
group.
To Next Page
Loading...
