Toshiba Satellite 2670 series - Accepting Changes and Exiting SYSTEM SETUP; Default Configuration; TSETUP Options

User's Manual Setup and Password Security 7-3
Version
1
Last Saved on 19/01/00 17:28
Satellite 2670/2710 User's Manual – 2670_UK.doc – ENGLISH – Printed on 19/01/00 as
IM_267UK
Accepting changes and exiting SYSTEM SETUP
1.
Press
End
to accept the changes you made.
If the changed item does not require the system to reboot, the following
message is displayed:
Are you sure? (Y/N)
If the changed item requires the system to reboot, the following
message is displayed:
Are you sure? (Y/N)
The changes you made will cause the system to
reboot.
2.
To make other changes, press
N
. Repeat the steps above.
3.
To accept the changes, press
Y
.
You can press
Esc
to quit at any time without saving changes. TSETUP
asks you to confirm that you don’t want to save your changes.
Default configuration
When you access TSETUP, the current configuration is displayed.
1.
To show the default configuration, press
Home
.
2.
To accept the default settings, press
End
and then press
Y
.
When you execute the default setting, the following settings are not
changed:
• Hard Disk Mode
• Password
• Write Policy
TSETUP options
The SYSTEM SETUP screen is divided into functionally related groups.
This section describes each group and its options.
Most functions described in this section can also be changed using
Toshiba’s Hardware Setup or Power Saver Utility in Windows. The I/O
port, IRQ and DMA channel are set in Windows 98 Device Manager.