User's Manual The Keyboard 5-5
Version
1
Last Saved on 30/04/00 19:48
Satellite 2750/2770 User's Manual – Satellite 2750 UK.doc – ENGLISH – Printed on 30/04/00 as
IM_275UK
Fn
+
F3
Power up mode:
Pressing
Fn + F3
changes the power up mode. When
you press these hotkeys, the current setting will be displayed in a window.
Continue holding down
Fn
and press
F3
again to change the setting. Use
the
When I press the power button
feature of
System Power Mode
tab in
Power Saver. This function changes the power up mode only when you
start the computer by pressing the power button.
F4
Fn
+
Alarm volume:
Press
Fn + F4
to adjust the alarm volume to off, low, medium
or high. The first time you press
Fn + F4
the volume is set to off. Continue
holding down
Fn
and press
F4
again to change the setting. A beep sounds to
let you know the current alarm volume. The volume at power on depends on
the latest setting. See Chapter 7,
Setup and Password Security
.
Fn
F5
+
Display selection:
Pressing
Fn + F5
changes the active display device. As
indicated in the table below, the changes depend on the computer’s display
type, current setting and whether you have an external monitor connected.
LCD only
LCD/CRT
CRT only
LCD/TV
TV only
(back to LCD only)
The LCD/TV setting can be selected only when the computer is in dual
controller mode.
To set this mode, follow the steps below.
•
Click Start, point to Settings and click Control Panel.
•
Double-click the
Display
icon to open the Display Properties window.
•
Click the Settings tab and click the
Advanced
button.
•
Click the
S3 DuoView+
tab and in the Controller Options box, select
Dual controller
.
If a television is connected to the computer, set the TV type in the Display
Properties window.
To Next Page
Loading...
