Toshiba SATELLITE 2750 Series - Power on Display

User's Manual TSETUP and Passwords 7-9
Version
1
Last Saved on 30/04/00 19:48
Satellite 2750/2770 User's Manual – Satellite 2750 UK.doc – ENGLISH – Printed on 30/04/00 as
IM_275UK
Power on Boot Select
When this option is enabled, you can change the boot drive during start
up. The following message will appear for one or two seconds
Press
[F2] for the boot drive selection menu
.
To change the boot drive, follow the steps below.
1.
Press
F2
while the above message is on the screen.
2.
The following menu will be displayed:
Select boot device
[C]: CD-ROM
[F]: FDD
[B]: Built-in HDD
[D]: Default SYSTEM SETUP Device
Press [C], [F], [B] or [D]
If a supervisor password is set, the menu above does not appear when
you use the user password to start the computer.
In this computer, CD refers to the DVD drive.
Press the key (
C
,
F
,
B
or
D
) corresponding to the desired device.
The selection method above does not change the boot priority settings in
Hardware Setup or TSETUP.
If you press a key other than one of those above or if the selected device
is not installed, the system will boot according to the current setting in
Hardware Setup
or TSETUP.
Display
This group of options lets you configure the computer’s display. Refer to
Hardware Setup for details on the settings.
Power On Display
Lets you set the display to be used when the computer is booted.
Auto-Selected
Selects an external monitor if one is connected.
Otherwise, it selects the internal LCD. (Default)
Simultaneous
Selects both the internal LCD and external
monitor for simultaneous display.