4 Replacement Procedures 4.3 Speaker over and Keyboard
3. Remove two M2.5x2.6 black bind securing screws.
4. Disconnect the keyboard cable from CN11 on the system board.
Figure 4-13 Removing the keyboard
Installing the Speaker Cover and Keyboard
Install the speaker cover and keyboard according to the following procedures and Figures 4-
12, 4-13.
1. Connect the keyboard cable to CN11 on the system board.
2. Secure the keyboard with two M2.5x2.6 black bind screws.
3. Place the speaker cover in the correct position and secure the following 10 latches, in
that order:
- Six bottom latches
- Four front latches
4. Close the display and turn the computer over.
4-26 Satellite A100/A105 / TECRA A7 Maintenance Manual
To Next Page
Loading...
