4.7 Display Assembly 4 Replacement Procedures
Figure 4-20 Removing the display assembly
Installing the Display Assembly
Install the display assembly according to the following procedures and Figures 4-19, 4-20.
1. Place the display panel in the correct position and push the wireless antenna cable
into the top cover.
2. Connect the LCD/FL cable to CN3 on the system board.
3. Secure the display assembly with four M2.5x5 black flat-head screws.
4. Close the display panel and turn the computer so the back is facing you and secure it
with two M2.5x5 black flat-head screws.
Satellite A100/A105 / TECRA A7 Maintenance Manual 4-35
To Next Page
Loading...
