Toshiba Satellite A100 - System Board, USB Board, AC-IN Cable; Removing the System Board, USB Board, AC-IN Cable; Display Mask

4.13 Display Mask 4 Replacement Procedures
4.13 System Board, USB Board, AC-IN cable
Removing the System Board, USB Board, AC-IN cable
NOTE: Be careful of the eject button for the PC card. It can be damaged when
removing the board. Make sure it is securely installed.
Remove the System Board, USB Board, AC-IN cable according to the following procedures
and Figures 4-32.
1. Remove MIC from CN28 on the system board.
2. Remove one M2x4 black flat-head screw.
3. Remove the RJ11 cable from CN50 on the system board and then remove the system
board.
Figure 4-32 Removing the system board
4. Turn the system board upside down.
5. Remove the AC-IN cable from CN503.
Satellite A100/A105 / TECRA A7 Maintenance Manual 4-51