4.15 LCD Module 4 Replacement Procedures
4.15 FL Inverter Board
Removing the FL Inverter Board
Remove the FL inverter board according to the following procedures and Figure 4-34.
1. Remove one M2.5x4.5 white flat-head screw.
Figure 4-34 Removing the FL inverter board
2. Lift the LCD module, FL inverter board and disconnect the LCD/FL cable from the
LCD/FL connector.
3. Disconnect the HV cable from the HV connector and remove the FL inverter board.
Satellite A100/A105 / TECRA A7 Maintenance Manual 4-55
To Next Page
Loading...
