4.16 LCD Module 4 Replacement Procedures
4.16 LCD Module
NOTE: ICs are fragile. Use extreme care not to apply pressure to the ICs along the
edges of the LCD module.
NOTE: Dispose of used LCD panels (fluorescent (FL) tubes) as required by local
ordinances or regulations.
NOTE: The LCD/FL cable must be carefully peeled away before disconnecting it from
the module.
Removing the 15.4-inch LCD module
Remove the 15.4-inch LCD module according to the following procedures and Figures 4-35,
4-36.
1. Carefully tilt the LCD module toward you.
2. Remove two M2x3 white flat-head screws on each side securing the LCD bracket.
Figure 4-35 Removing the 15.4-inch LCD module and screws
Satellite A100/A105 / TECRA A7 Maintenance Manual 4-57
To Next Page
Loading...
