4 Replacement Procedures 4.17 Speakers
4.17 Speakers
Removing the Speakers
Remove the Speakers according to the following procedures and Figure 4-37.
1. Remove one M2.5x4 black flat-head screw securing the left speaker.
2. Remove two M2.5x4 black flat-head screws securing the right speaker.
3. Remove the left and right speakers.
Figure 4-37 Removing the speakers
Installing the Speakers
Install the speakers according to the following procedures and Figure 4-37.
1. Seat the left and right speaker in the correct position.
2. Route the speaker cable in the wire guide.
3. Secure the left speaker with one M2x4 black flat-head screw.
4. Secure the right speaker with two M2x4 black flat-head screws.
4-60 Satellite A100/A105 / TECRA A7 Maintenance Manual
To Next Page
Loading...
