User’s Manual
9-20
T
ROUBLESHOOTING
Standby/Hibernation
A CONNECT display is
quickly replaced by
NO CARRIER
Check the error control setting in your communi-
cations application.
You can also use the AT\N command. Refer to
the chapter on AT commands in online help files
for Appendix C, AT Commands.
Character display
becomes garbled
during a
communication
In data transmission, make sure the parity bit
and stop bit settings correspond with those of
the remote computer.
Check the flow control and communication pro-
tocol.
You cannot receive
an incoming call
Check the rings before auto answer setting in an
incoming call your communications application.
You can also use the ATS0 command. Refer to
the chapter on S-registers in online help files for
Appendix D, S-registers.
If problems persist, contact your dealer.
Problem Procedure
The system will not
enter Standby/Hiber-
nation
Is Windows Media™ Player open? The system
might not enter Standby/Hibernation, if Windows
Media Player is either playing a selection or fin-
ished playing a selection. Close Windows Media
Player before you select Standby/Hibernation.
If problems persist, contact your dealer.
Problem Procedure
To Next Page
Loading...
