4.9 Keyboard 4 Replacement Procedures
4. Disconnect the keyboard FPC cable and remove the keyboard.
Figure 4-19
Disconnecting the keyboard cable
Installing the Keyboard
To install the keyboard, follow the steps below and refer to the figures in the preceding
section.
1. Connect the keyboard FPC cable to the system board.
2. Set the keyboard in place and secure it with two black M2x3 screws.
3. Set the strip cover in place and press down to secure the strip cover latches engage.
Detroit 20 /Detroit 20E Series Maintenance Manual [CONFIDENTIAL] 4-21
To Next Page
Loading...
