4.15 Speakers 4 Replacement Procedures
4.15 Speakers
Removing the Speakers
To remove the speakers, first remove the top cover, system board and then follow the steps
below:
1. Remove two M2.5x3 screws from the right speaker.
2. Remove two M2.5x3 screws from the left speaker.
Figure 4-33
Removing the speaker screws
3. Lift out the speakers.
Installing the Speakers
To install the speakers, follow the steps below and refer to the figure in the preceding section.
1. Seat each speaker in the chassis.
2. Secure the left speaker with two M2.5x3 screws.
3. Secure the right speaker with two M2.5x3 screws.
Detroit 20 /Detroit 20E Series Maintenance Manual [CONFIDENTIAL] 4-31
To Next Page
Loading...
