52
Getting Started
Adding memory (optional)
If your system has the memory modules stacked on top of one
another, you must remove the top module first before
removing/installing the bottom module.
For this model, Slot A is the bottom slot. Slot B is the top slot. If only
one memory is to be installed, it must be installed in Slot A.
11 Pick up the memory module by its sides, avoiding any contact
with its connector. Position the module toward the socket, aligning
the connector’s notch with the matching key in the socket.
(Sample Illustration) Aligning the memory module with the socket
12 Firmly press the memory module into the memory slot’s socket
at approximately a 30-degree angle (to the horizontal surface
of the computer).
(Sample Illustration) Inserting the memory module into the socket
13 Once the module’s connector is fully inserted into the socket,
press downward on the top edge of the module to seat the
module into the latches at the sides of the socket. These latches
should “snap” into place securely with the corresponding
latch
latch
key
notch
connector
To Next Page
Loading...
