Toshiba Satellite A200 Series - Data Verification

4-24 Satellite A200/Satellite Pro A200
Operating Basics
■ Do not use the "Disc Backup" function of TOSHIBA Disc Ceator to copy
DVD-Video and DVD-ROM with copyright protection.DVD-RAM media
cannot be backed up with the “Disc Backup” finction of TOSHIBA Disc
Ceator
■ You cannot back up a CD-ROM or CD-R/RW to DVD-R/-RW or DVD+R/
+RW using the Disc Backup function of TOSHIBA Disc Ceator
■ You cannot back up DVD-ROM, DVD-Video or DVD-R/-RW or DVD+R/
+RW to CD-R/RW using TOSHIBA Disc Ceator
■ TOSHIBA Disc Ceator cannot record in packet format.
■ You might not be able to use the Disc Backup function of TOSHIBA Disc
Ceator to backup a DVD-R/-RW or DVD+R/+RW disc that was made
with other software on a different DVD-R/-RW or DVD+R/+RW recorder.
■ If you add data to a DVD-R and DVD+R disc that you have already
recorded to, you might not be able to read the added data under some
circumstances. It cannot be read in 16-bit operating systems, such as
Windows 98SE and Windows ME, in Windows NT4 you will need Service
Pack 6 or later to read the data, and in Windows 2000 you will need
Service Pack 2 or later to read it. Some optical media drives cannot read
added data regardless of the operating system.
■ TOSHIBA Disc Ceator does not support recording to DVD-RAM discs.
To record to a DVD-RAM, use Explorer or other similar utility.
■ When you back up a DVD disc, be sure the source drive supports
recording to DVD-R/-RW or DVD+R/+RW discs. If the source drive does
not support recording to DVD-R/-RW or DVD+R/+RW discs, it might not
be backed up correctly.
■ When you back up a DVD-R, DVD-RW, DVD+R or DVD+RW, be sure to
use the same type of disc.
■ You cannot partially delete any data written to a CD-RW, DVD-RW or
DVD+RW disc.
Data Verification
To verify that data is written or rewritten correctly, follow the steps below
before you write or rewrite a Data CD/DVD.
1. Display the setting dialog box by one of the following two steps:
■ Click the setting button ( ) for writing on the main toolbar in the Data
CD/DVD mode.
■ Select Setting for writing Data, and go to CD/DVD in the Setting menu.
2. Mark the Verify written data check box.
3. Select File Open or Full Compare mode.
4. Click the OK button.