4 Replacement Procedures
Minnesota 10M/10MG Series Maintenance Manual 4-19
3. Push the latches to release the memory module. A spring will force one end of the
module up.
Figure 4-18 Releasing the memory module
4. Grasp the module and pull it out.
Figure 4-19 Removing the expansion memory module
5. Repeat steps 3 and 4 to remove the second memory expansion module in the same way.
CAUTION: Do not touch the connectors on the expansion memory module or on the
computer. Debris on the connectors may cause memory access problems.
To Next Page
Loading...
