4 Replacement Procedures
Minnesota 10M/10MG Series Maintenance Manual 4-33
4.11 Display Mask
Removing the Display Mask
To remove the display mask, first remove the display assembly as described earlier, and then
follow the steps below:
1. Remove four rubber pads to reveal the four M2.5x6 screws securing the display mask to
the LCD module.
Figure 4-35 Removing the rubber pads
2. Remove the four M2.5x6 black screws securing the display mask.
Figure 4-36 Removing the display mask screws
To Next Page
Loading...
