4 Replacement Procedures
Minnesota 10M/10MG Series Maintenance Manual 4-35
4.12 FL Inverter Board
Removing the FL Inverter Board
To remove the FL inverter board, first remove the battery pack, display assembly, and display
mask; then follow the steps below.
1. Remove the M2x3 black screw securing the FL inverter board to the LCD display
assembly.
Figure 4-38 Removing the screw
NOTE: If a dual inverter board is installed, you must remove two additional M2.5x4
screws.
2. Disconnect the two connectors on either side of the board.
Figure 4-39 Removing the connectors
To Next Page
Loading...
