4 Replacement Procedures
Minnesota 10M/10MG Series Maintenance Manual 4-37
4.13 LCD Module
Removing the LCD Module
To remove the LCD module, first remove the display assembly, display mask, and FL
inverter board and then follow the steps below.
1. Unhook all cables from the fasteners around the edge of the top chassis.
Figure 4-41 Removing the LCD Module
2. Remove four M2.5x4 screws securing the top chassis to the LCD module, and two
M2.5x5 screws securing the hinges to the LCD module.
Figure 4-42 Removing the LCD Module
To Next Page
Loading...
