4 Replacement Procedures
Minnesota 10M/10MG Series Maintenance Manual 4-41
4.15 Camera and Microphone
To remove the camera and microphone, first remove the display assembly, display mask, FL
inverter board and the LCD display module. Then follow the steps below.
1. Remove the CMOS cable from the camera module. Remove the camera module by gently
peeling it away from its adhesive backing.
Figure 4-47 Removing the CMOS cable & camera
2. Use a flat screwdriver to lever the microphone module from its bracket and gently lift out.
Figure 4-48 Removing the microphone
To Next Page
Loading...
